New Yankee Workshop Episode 9911

In this episode, building a press cupboard, Norm used the following tools:

• Angle Wright A30 miter gauge
• Awl
• Backsaw, brass backed
• Bessey K-body clamps
• Bessey GH clamp
• Bessey GRZ Super-Grip clamp
• Bessey Tradesman clamps
• Center finder
• Dado blade (stacked)
• Dado insert
• Dead blow hammer
• Delta 17-925 drill press
• Delta 28-280 band saw
• Delta 43-188 sliding shaper jig
• Delta 46-700 lathe
• Delta DJ-20 jointer
• Roller glue bottle
• Leigh dovetail jig
• Panel cutting jig
• Porter-Cable 693 plunge router
• Porter-Cable 862 cordless drill
• Porter-Cable BN200 brad nailer
• Router table, shop made
• Senco SLP20 brad nailer
• Shelf pin jig, shop made (simplified version of the one pictured in the link)
• Stanley block plane
• Timesaver wide belt sander
• Tru-Grip clamp
• Try square
• Unisaw
• Unifence
• Insert, melamine
• Insert, oak insert
• Insert, red
• Vise-Grip locking pliers

An infrequent no-new-tool episode.

Norm used a plain board clamped to the Unifence as a sacrificial fence.

The safety speech included video of an operation on the router table.

No field trip this episode.

This episode was processed based on the full length original broadcast by PBS.