New Yankee Workshop Episode 908

In this episode, building a carousel table, Norm used the following tools:

• Bessey K-Body clamps
• Bessey GH clamp
• Bessey GRZ Super-Grip clamp
• Bessey Tradesman clamps
• Biesemeyer T-square fence
• Bosch 1584 jig saw
• Dado blade (stacked)
• Dead blow hammer
• Delta 14-600 mortiser
• Delta 17-900 drill press
• Delta 28-280 bandsaw
• Delta 31-280 sanding center
• Delta 33-890 12" radial arm saw
• Delta 34-182 tenoning jig
• Delta 34-895 miter gauge
• Delta 46-700 lathe
• Delta DL-40 lathe
• Delta lathe duplicator
• Delta lathe steady rest
• Delta DC-33 planer
• Delta DJ-15 jointer
• Drill 'n Drive bits
• Lamello Top 20 biscuit joiner
• Lamello Dosicol glue bottle
• Performax drum sander
• Porter-Cable 691 router
• Porter-Cable Laser-Loc miter saw
• Porter-Cable 862 cordless drill
• Router table (shop built)
• Sanding drum for drill
• Taper jig (home-made)
• Tru-Grip clamp
• Unifence
• Unisaw
• Insert red
• Oak insert insert

Items in bold represent the first appearance of that particular tool.

Yes, as unbelievable as it may seem, Norm used two lathes in this project.

Also odd, Norm mentioned finish sanding a couple of times, but never actually did any—no random orbit sanders or pad sanders used in this episode.

The safety speech included video of a crosscut operation on the radial arm saw—oblique view.

Field trip was to a private home near Savannah, Georgia.

This episode was processed based on the full length original broadcast by PBS.