New Yankee Workshop Episode 903

In this episode, building a Nantucket settle, Norm used the following tools:

• Angle Wright A20 height gauge
• Backsaw, brass backed
• Bessey K-Body clamps
• Bessey GRZ Super-Grip clamp
• Bessey Tradesman clamps
• Biesemeyer T-square fence
• Chisels
• Claw hammer
• Combination square
• Dado blade (stacked)
• Dado insert
• Dead blow hammer
• Delta 14-600 mortiser
• Delta 17-900 drill press
• Delta 28-280 bandsaw
• Delta 31-280 sanding center
• Delta 33-890 12" radial arm saw
• Delta 34-182 tenoning jig
• Delta 34-895 miter guage
• Delta 46-700 lathe
• Delta DJ-15 jointer
• Hitachi DS10DVA cordless drill
• Mallet
• Porter-Cable 691 D-handle router
• Porter-Cable 853 cordless drill
• Porter-Cable LaserLoc miter saw
• Rasp
• Router table (shop built)
• Senco SLP-20 brad nailer
• Star oscillating spindle sander
• Unisaw
• Unifence
• Insert melamine
• Insert oak
• Utility knife

An infrequent no-new-tool episode.

Norm used a plain board clamped to the Unifence as a sacrificial fence.

In a highly unusual departure from the normal sequence, Norm actually made a cut using power tools before beginning the safety speech.

The safety speech included video of a crosscut operation on the radial arm saw—oblique view.

Norm added hearing protection to his safety advisory.

Field trip was to a private residence, undoubtedly Morash's, in Massachusetts.

This episode was processed based on a broadcast by HGTV.