New Yankee Workshop Episode 708

In this episode, building a sailboat (part one of a two part project), Norm used the following tools:

• Bessey K-Body clamps
• Bessey Tradesman clamps
• Bessey GRZ Super-Grip clamp
• Biesemeyer fence
• Biesemeyer T-Square
• Bosch 1272 belt sander
• Bosch 1584 jig saw
• "C" clamp
• Claw hammer
• Combination square
• Delta 17-900 drill press
• Delta 28-280 band saw
• Sanding drum for drill press
• Drill-N-Drive bits
• Glue scraper
• Hand saw
• Hitachi DS10DVA cordless drill
• Hot melt glue gun
• Insty Bit
• Porter-Cable 314 trim saw
• Porter-Cable 330 pad sander
• Porter-Cable 333 random orbit sander
• Porter-Cable 840 cordless drill
• Porter-Cable 853 cordless drill
• Porter-Cable Laser-Loc miter saw
• Spring clamp
• Stanley block plane
• Taper jig
• Unisaw
• Original insert
• Insert, oak insert

Items in bold represent the first appearance of that particular tool.

The Powermatic planer, to be introduced near the end of this 7th season can be seen lurking in wait in the overhead shot near the end of the episode.

The safety speech included video of a crosscut operation on the radial arm saw.

Field trip was to The Center for Wooden Boats, Seattle, Washington.

Thanks to my friend, Steve Kuhn for the   “Epoxy video”  in which we find that over the course of these two episodes, Norm said epoxy 40 times!

This episode was processed based on the concatenation of the two full length originals posted on The New Yankee Workshop website. Total duration 47′ 13″