New Yankee Workshop Episode 9908

In this episode, building a table saw station, Norm used the following tools:

• Angle Wright A30 miter gauge
• Bessey GRZ Super-Grip clamp
• Bessey Tradesman clamps
• Bevel gauge
• Biesemeyer T-Square
• Bosch 1584 jig saw
• Dado blade (stacked)
• Dado insert
• Dead blow hammer
• Delta 17-925 drill press
• Delta 28-280 band saw
• Delta 31-780 BOSS
• Delta 34-895 miter gauge
• Delta 36-275 Sidekick benchtop saw
• Framing Square
• Jack Rabbit driver
• Jorgensen pipe clamps
• Lamello Dosicol glue bottle
• Panel cutting jig
• Porter-Cable 314 trim saw
• Porter-Cable 557 biscuit joiner
• Porter-Cable 691 D-handle router
• Porter-Cable router edge guide
• Porter-Cable 862 cordless drill
• Porter-Cable BN200 brad nailer
• Porter-Cable FN250 finish nailer
• Porter-Cable Laser-Loc miter saw
• Quick-Grip clamp
• Tru-Grip clamp
• Unisaw
• Unifence
• Insert, oak insert
• Insert, red

Items in bold represent the first appearance of that particular tool.

Norm used a plain board clamped to the Unifence as a sacrificial fence.

In addition to the saw stand itself, Norm built sawhorses, a panel cutting jig, a push stick, and a feather board.

The safety speech included video of a crosscut operation on the radial arm saw.

No field trip this episode.

This episode was processed based on the full length original broadcast by PBS.