New Yankee Workshop Episode 1402

In this episode, building a miter bench (part two of a two part project), Norm used the following tools:

• Angle Wright A30 miter gauge
• Bessey GRZ Super-Grip clamp
• Bessey Power-Grip clamp
• Bessey Tradesman clamps
• Biesemeyer fence
• Biesemeyer auxiliary fence (long)
• Chisels
• Claw hammer
• Combination square
• Dado blade (stacked)
• Dado insert
• Dead blow hammer
• Delta 17-925 drill press
• Delta 28-280 band saw
• Delta 34-895 miter gauge
• Jack Rabbit driver
• Jorgenson 37xx F-type bar clamp
• Lamello Top 20 biscuit joiner
• Osborne miter gauge
• Porter-Cable 310 laminate trimmer
• Porter-Cable 862 cordless drill
• Porter-Cable NS100 stapler
• Senco SLP20 brad nailer
• Star oscillating spindle sander
• Tru-Grip clamp
• Unisaw
• Insert, oak insert
• Utility knife

Items in bold represent the first appearance of that particular tool.

The safety speech included video of an operation on the router table (finger slip).

No field trip this episode.

This episode was processed based on the full length original broadcast by PBS.